I think a already know the answer but just need confirmation. I want to run 94-95 LT1 PCM just to control 4L60E on SBC350 carbed. Do i get right just to use coolant sensor, TPS, disable all engine related codes and will be good to go?
Best regards
Printable View
I think a already know the answer but just need confirmation. I want to run 94-95 LT1 PCM just to control 4L60E on SBC350 carbed. Do i get right just to use coolant sensor, TPS, disable all engine related codes and will be good to go?
Best regards
pretty sure itll need rpm, and unless you hack it in unknown ways, it'll need an opti to get rpm
there are probably better choices, perhaps use a tbi ecm that was used with a 4l60e
Thanks, forgot about that opti rpm signal.
Best regards