How Do I do this....

i am trying to put a fan control into my $0d bin using tunerpro bin editor. so i find the bin location 7000 and i manually enter the code because everytime i copy and paste i get tons of garbage output. so after i enter the entire code do i just manually hardwire the fan relay as directed? is the code all i need or do i need to do anything to the algorithm? also how do i do this.to able this routine, be sure to change the Value at address 7C6F from D399 to 7020.?http://www.gearhead-efi.com/Fuel-Inj...E-Efan-control

I'd use a hex editor to enter this data then run the cal through a tuner afterward to get the checksum correct. If you can enter the code manually you should be able to make the last change above. Go to $7C6F in the hex editor and change the value there to 7020.

I used TunerPro RT to make the edit, and worked fine. Saved the bin afterward, and it works well.

Quote:

---

Originally Posted by Six_Shooter

I used TunerPro RT to make the edit, and worked fine. Saved the bin afterward, and it works well.

---

X2 I used the xdf included in the zip file to load the code and set the fan parameters. from there I just hard wired the relays to the specified pins and poof it all worked.