How the heck..????? (EBL wire harness)
Wanted to see if I could get some tips here.
I am trying to remove the red and blue connectors from a burned out PCM (Thanks again for the help on this Richard!) to make a wire harness for an EBL install. I've seen some other threads where guys take the red and blue PCM connectors out of a donar PCM and then use a set of wire harness connectors to make up a wire harness so you can run the EBL ECM and the stock PCM as needed on my particular truck 16197427.
I did my best to de-solder the pins but there is some sort of glue or coating on the board that I think is helping to hold the connectors to it. Is there something to remove that or do I not even worry about that? I don't want to break any pins on the connector by prying too hard. Has anybody done this before that could give me some tips?
thanks.!!