so im adding an electric fan and would like to have my 7427 pcm control it. i found the table to enter in the hex editorbut not clear on what to do after that.
Printable View
so im adding an electric fan and would like to have my 7427 pcm control it. i found the table to enter in the hex editorbut not clear on what to do after that.
What mask are you using? Is it $0D, $0E, $E6 or $31? I hand edited my bin and entered the code using the hex editor. It works great in $0D. After you enter the code, you have to wire in a fan relay. The PCM turns on the ground side of the coil for the fan relay to make the fan run with the temps you set in the code. Which fan code are you wanting to use?
I'm using $0D mask and tps,soft start,transmission fan code I entered it into the hex editor and I understand I have to wire the ground for my fan relays to pin E3 but where do I adjust on off temps in tunerpro
I think I have that xdf don't have my laptop with me if it is the same xdf when I opened it all I saw was the fan controls do I use it for the fans then switch xdf for everything else
that was not the xdf I had I tried downloading the xdf you posted but I get a php file I am totally lost now
Right click the link and save as....
I tried that still getting a php file and windows wont open it
changed the file extension now when I try to select that xdf tunerpro comes back with an invalid xdf
What Operating System and browser are you using?
Windows 7 and internet explorer
I have no problem saving the link from Linux using Firefox or XP using IE. There is nothing wrong with the xdf file posted above by Nasty-Z.
I'm sure there is nothing wrong with the xdf it's something I'm doing wrong now any bin or xdf I try to download from gearheadefi comes up a php file I'll have a friend who does IT work look at it tomorrow I have no idea what to do now
Try Chrome or Firefox, I've given up on IE.