You can play with the multiplier table and ramp out to keep it longer in effect. I noticed some vette calibrations have these bumped up a little.
Printable View
Ramp out scalar is in Pump shot catalog, but where is that multiplier table? Maxed out table almost did the job :-)
124b4 Derivative Gain Vs. Coolant Temperature
This one is the multiplier table corrected with baro multiplier 126af HIGH BARO TABLE. The result is used as a multiplier to the main table.
Thanks a million, that did the job so SD mode can have fully functional Accel Enrichment. No more to MAF :-)
Best regards
my setup is LT1, alum heads with 1.6RR, shorties, 2,5 dual straight pipes, 4L60E with 3000 stall converter. Maxed out table except 0% TPS obviously, then multipied Derativ gain by 1.2 and my one runs like a beast now!
best regards
kur4o,
Have you ever looked at a table to pull timing for nitrous using a pin on the pcm to activate?
The traction spark retard table can be used for nitrous retard. It even have some blend out with timer when retard is over.
If you don`t have a vette car with Traction or other platform with traction than you can use external pin for activating retard.
The pin is C12 and you must provide a B+ voltage to activate.
I seen you talked about having an patch that reads voltage at the injectors for the ls injector patch. Is it posted anywhere?
It's included in the LS INJ HACK that's a part of EEXTRA, I believe. So enabling the patch will enable that function and set up the VACUUM VS VOLTS tables for you.
http://gearhead-efi.com/Fuel-Injecti...ll=1#post89095
What about the wire you added to get a more direct reading of injectors
Where are you seeing this? Can you provide a link to such a modification?
The only reference I saw kur4o making to his LS INJ Patch was for...well, all the changes necessary to run LS injectors on our PCM, since the documentation on LS injectors is far more complete than any other injector we have available, and thus it's easier to fine-tune them.
Ah, I see. Well considering it never went anywhere since 2018, I'm gonna bet he found out the benefits were so miniscule as to make the effort meaningless, which is why that function doesn't appear in any of his subsequent XDFs (including the one from only a few months ago I just posted). You're probably good without the wire and extra stuff. Just run the patch as-is.
But that's just me. kur4o can always jump in and be more specific for ya. Peace!