Update: The car is running very well, I have made several drag strip runs deep down into the 12s but it is eating parts now. First was the stock rear end then the transmission, I have pulled the...
Type: Posts; User: 63LT1Vette
Update: The car is running very well, I have made several drag strip runs deep down into the 12s but it is eating parts now. First was the stock rear end then the transmission, I have pulled the...
Sorry for no updates for a while, I had to step away from the project for a while but I am ready to continue now.
The car starts good and idles well I have drove it some and it is rich. (very good...
Yes I have made a couple of short street runs, It is running OK. I have been working off of the original tune from you. I never did get he second one to run, it will run in the green the wbo2 to...
Thanks for the info Tequilaboy I will keep this in mind, The $12p code is getting a little easier to work with so I am going to stay with it right now.
I worked on this again this weekend, and still no go. It will start and run with the first tune but not this one.
Yes I killed all power during chip swap.
This one is a no run, Tried it twice, the check engine light comes on with the key and the fan also comes on with the key but no start. Didn't have time to check for injector firing yet.
All flags cleared and nothing coming up any more. it is running rich "good". but it cranks and runs good, Idle is at 1000 rpm, temp is acting funny. need to look at the values some more (dash gauge...
thank you, I had some problems today that turned out to be an electrical issue at the fuse box, I think I got it fixed so maybe Ill get to get back on the tuning tomorrow.
That is correct
I have a set of 80 lb/hr just waiting patiently for everything to get right.
It started fine, reved up to about 1800 rpm's, started to come down hunting Idle and settled at 1000 rpm's. it seams to rev up fine but I have only been able to just sit in the shop today because of...
Success, Car is running with the 165 ECM and $12p. I really don't know what is different though, I reburned the chip last night and stacked the bin even though I don't think I needed to, today I...
Both are 165's one is the original from the car and the second is from an 86 that I have.
Yes everything is verifying good.
Went through all of that both ways today, same results.
I have just stacked the bin and reburned the chip, will give it another try tomorrow. Thanks again Delcowizzid.
I am second guessing myself now that I think back, The check engine light may have been on. I was attempting to start car from standing outside and watching the noid light. I am using the Motes APU1...
I'm thinking back and even if the chip is bad, I would have thought the car would run in limp mode?
yes, yes, yes, no. Two different chips, two different codes, I'm scratching my head. I'm new at burning my own chips but I have read everything twice, three times LOL. Can someone explain "stacking"...
Today was another day in the shop, Got the wiring taken care of. but still no injector fire with the $12, I am sure it is my inability to burn a chip correctly. I have two ECM's so I am able to...
I am having a lot of fun with this. It is tremendous learning experience.
I put in the MAP, is there something else I should change? It doesn't fire the injectors.
I was able to get back in the shop today, I installed a 3 bar MAP, I burned a chip with a bin of $12, it wouldn't fire the injectors. I'm not sure I have the wiring right for the $12 yet. I only...
downloaded just fine on an older computer, Windows XP.