I thought I had replied. Thanks EDZIP, where did you purchase your sockets. I have 2 types in which both have their pros and cons.
Type: Posts; User: troutdog311
I thought I had replied. Thanks EDZIP, where did you purchase your sockets. I have 2 types in which both have their pros and cons.
I apologize for hijacking this post. Finally had time to mess with it today. After much testing I finally got it going. Apparently the chip has to be seated way further up than I thought. I know a...
Thanks EDZIP, I do have 9 chips total. Well tried the BNDH file and fans came right on as I turn the key. I actually tried to start it for craps and giggles and would fire right up but go dead 5 sec...
Thank you kur4o for the help. I can't connect to the PCM at all at the moment using aldl at all. To program the chip I'm using a TL66 chip programmer. I just located the last known working 28F512...
Guys I don't know what to say. I'm so disappointed. I checked every pin with a meter and by seeing if they were firmly soldered by lightly pushing on them with the back side of a knife. I did find...
Well I'm first to admit when I do something stupid. Few weeks ago I was not able to connect to the PMC to flash. The engine would cut off and on repeatedly. I opened the PCM up and all my soldering...
Thanks for the advice. I did install the floor after installing the first chip the very first time I could tell right off it was too far down. Had a hard time pulling the chip out with the tool too....
Finally got the programmer in yesterday. It 3 tries but the 3rd times the charm right. The first time I used the Flash BlueGray file above. After I programmed the chip and installed all seemed well....
Found some Flash AN28F512 chips. Will any eprom socket work? Sorry for the back to back post. I have some free time at the office.
Killed my 16188051 this weekend mid flash. I cannot find the ED80009-ND socket nor the AN28F512 chip online besides in bulk. I tried searching many different keywords without any luck. I've replace a...