Anyone have an 08-10 Hummer H3 .Cal file?
Type: Posts; User: Tom B.
Anyone have an 08-10 Hummer H3 .Cal file?
Thank you for picking up the ball after Moates put it down. I have purchased a lot of products from them over the years. I wish they would've given their customers a heads up.
I never saw the question. I would have done it directly. I will do it asap. I couldn't do anything on this site for a week. Every time I attempted to post, i got the message asking me if I wanted to...
Here is a screen shot of what I am dealing with. I've been trying to upload this for a week.
17046
In the MEFI 5 system does anyone what the [#220] error represents?
*UPDATE* Turned out to be a bad box. Ken shipped a replacement air mail. They stand behind their product.
Here are the two errors when using the program. Does anyone have a working version of the executable that you can share?
:mad1:
with the cable plugged into a usb port
run-time error '8002':...
Thank you. This is what I have been trying to get for 3 weeks.
I'm sending up a flare. I have purchased both the MEFI 1-4 Scan and tune software and the MEFI 5 software. The latest MEFI software on the the thumb drive does notwork and does not have install...
You need the cam sensor. If you have to do the crank sensor re-learn, you need to ground the parking brake pinout. The PCM won't do the re-learn without the ground signal. I'll have to look at my...
You should be fine with them in the collectors. Back to basics, do you have a leaky flange gasket? That will pull air into the exhaust and create a lean reading at the O2 sensor.
MEFI 5. I'm only interested in doing one boat for a friend. I was hoping not have to spend the big cash on the software. (I know... B.O.A.T. means "bust out another thousand"). I have TunerPro,...
Has anyone done any tuning with the MEFI systems using TunerPro?
Never-mind, I found one.
Does anyone have a copy of the schematic for the proper pinout sequence for the harness? I am working on a 6.0 in a boat and some dummy pulled the wires out of the connector. The boat side of the...
You may have a mechanical problem with the PWM valve and bore wear in the valve body. Another issue may be that the PWM (95-newer) transmissions use a different tcc spool valve in the pump. If your...
The Delteq does use a Northstar module and coils.
You need to use the 96-97 cover. The crank damper mount is also shorter to accommodate the trigger wheel.
I'm glad you didn't have any major damage.
Try to turn the crankshaft using a socket and ratchet/breaker bar on the balancer bolt. If the engine will turn fairly smooth you should be OK. I would definitely put some lightweight oil in it and...
Did you shut the ignition off or did the engine lock up?
The Opti without the high voltage running through it will be just fine. Just clean it up and seal it. The same sensors seem to run forever in the other cars they are installed in.
I will say this once and then I am done with it. Valve overlap has a lot to do with the way it affects how an engine runs. If your position is to the contrary, I can only surmise you are less...
Hey now! We did get a little off topic for a minute. Anyways, I am committed to help you guys find a good, reliable, economical solution. I'm sure Fast 355 will be just as generous with his time...