ECM and Moates equipment sold.
Type: Posts; User: Chewy1576
ECM and Moates equipment sold.
Wideband gauge and Edelbrock 3704 manifold SOLD!
I did not try it on the EGR pin, I used one of the analog input channels on the APU1.
Here are a few pics.
It’s a 30-0300. I had to use one of the analog inputs on the Autoprom to get data from it.
Hey all,
I have converted my truck to a Fitech setup, so I don't need the TBI system or tuning equipment anymore. All prices are OBO also. I'll get some pictures of everything later.
Edelbrock...
Welcome! Good luck with the old 6.5L. I wish I could do my own tuning on my 1997.
Awesome, thank you!
I'll take the block off plate. I'll PM you.
This is awesome. I'm currently building an Arduino-based VGT controller for my GM 6.5L Diesel. After reading this, I think I will attempt to build a Speeduino for a TBI fed 383 I have in another...
I bought a 1" TBI spacer with the same footprint for the BB TB. Came with longer mounting bolts and new gaskets for top and bottom. It sealed just fine.
You had your 3740 intake bored out?...
Maybe I'll give it a try then. Hopefully the sensor I have is still in good shape.
The Spartan 2 looks promising. I can wire it to the EGR pin when data logging, and a gauge when not. I was looking at the PLX system also. Thanks for the recommendations.
Bump. Still looking. Any wideband gauge with 0-5v output for data logging would work too. Just want to get back in to tuning this 383.
I'm trying to sell a clean BB throttle body right now. Comes with spacer and IAC and TPS adapter harnesses. I have a set of 80 lb injectors too. The injector pod is no good though, but I'll track one...
Bump. Make offer.
I was planning to use these on my truck with the 383, but I bought another truck with a 6.5L and won’t need them anymore.
Bored out TBI intake - stock intake with throttle bores opened up to 2”...
I want to replace the gauge that was stolen earlier this year so I can dial in the tune with 61 lb injectors. I still have the 02 sensor, but the gauge and wiring were ripped out with the ECM.
This one works - https://chrome.google.com/webstore/detail/photobucket-hotlink-fix/kegnjbncdcliihbemealioapbifiaedg?utm_source=gmail
What color are the connectors? That will help narrow it down. Also, what is the broadcast code on the eeprom or memcal itself?
I have this board also. Works perfectly with 16197427 and TunerPro.
I'm using it with Win 10. Works fine for me.
On my cable, I didn't use a diode or a resistor. Just soldered the comm wire to both TX and RX, and the ground to ground.
Here's a log I took this morning. I'll make adjustments and burn a new chip when I get home tonight.
11663
Not sure where else to upload this, but I came across a 16197427 / BLHH ECM out of a K2500 Suburban. I couldn't find a .bin for BLHH anywhere, so I will provide it here.