Hey guys,
I need a stock calibration file for a 2002 yukon/tahoe with the following specs:
lm7
drive by wire
4l60e
I have found some files here on gearhead that have been close, but now...
Type: Posts; User: 96HawkCnvt
Hey guys,
I need a stock calibration file for a 2002 yukon/tahoe with the following specs:
lm7
drive by wire
4l60e
I have found some files here on gearhead that have been close, but now...
Hi,
Hoping that someone can post up a 2001 file that meets this:
2001 4.8L 4x4 4L60E 3.42 gear
I can change gear ratio easy enough, but would be nice if it is 4.8L & 4x4
TIA!
Todd
VIN - 1GKDM19W81B508777
Thanks!
I know that it is a strange request, but does anyone have a TC .CAL file for one of these?
Thanks!
Todd
Found it in a search. Thought I had already searched properly. Sorry for the wasted post.
As title says, I'm looking for a .cal from a 2002 5.7 Express Van. Stock file only please.
Thanks!
Thanks!
I've been searching through the posts here and haven't found a stock LS7 file (from C6 Z06). I would really appreciate it if someone could post one.
Thanks!
I had looked at that post. I just misread the descriptive file name, but yes it does look like what I need.
Very sorry Buzz.
I would really appreciate it if anyone here could post up a file for me. I need a completely stock file as follows:
2003
GMC
K2500
Regular Cab (I don't think that matters...)
6.0L
4.10 gear...
Agreed... significant differences in LT1 pcms.
'92 - '93 Would be from a Y-body or F-body ('93 only). You would be burning chips vs. flashing the pcm. Note however that these pcms are worth...
The attached file was setup for a 5.3L/T56 swap into an '85 RX7 although it should be a good base for a swap into other vehicles as well.
Base file: 2006 4.8L Manual Transmission Silverado
OS:...
Welcome altum! Tell us about what you will be tuning.
Welcome! Post a picture up of your Mondeo sometime.
Thanks! That was very helpful. I was able to find some LM7 files with the same OS as my LR4 MT file and then also found a 2006 L33 file (different OS) and was able to compare to an LM7 and then...
I'm going to give it a try today. Do you think it being DBC will mess me up when I'm only moving the trans module over?
And by the way, I do appreciate all the help :)
And still wouldn't...
Thanks Lextech, I may give that a try. I did also find a 4.8L MT file that looks good and I tried it last night. I swapped in a 5.3 engine module but after doing that it was in some sort of limp...
Thanks Buzz. That's very helpful. Wonder if anyone else here happens to have the files that I could use. Or I'll find the right truck on a used car lot and go for an extended "test drive" ;)
Maybe a misunderstanding... I'm not looking to make any changes to the DBW because it's working fine. I'm only asking about a manual transmission cal so that I could use it as a base or swap the...
The DBW is working fine so I don't really want to change to a 512k pcm. I can get the trans section setup for the T56, was just trying to save some time.
Welcome! I'm relatively new here as well. :) Seems like a great place and I intend to visit often.
I don't think that I can swap segments with that because the operating system will be different. True?
Thanks Lextech. The DBW components that we used (TB, TAC, Pedal assembly) are all from 2006. I first tried a 2004 file since I knew that there were 2004 manual trans & in fact there are some posted...
So we just fired up a 5.3 in my son's RX7 for the first time. Now that we have it running, I need to get the right tune dialed in for it. It is a L33 out of a 2006 Silverado with the associated DBW...
Thanks!