To tell you the truth I can't remember the reluctor tooth count, but the 94 Chevy cab is from a 2500 and on the 3500HD chassis. Yes running the speedo with a DIP equipped DRAC. Have extra DIP...
Type: Posts; User: EDZIP
To tell you the truth I can't remember the reluctor tooth count, but the 94 Chevy cab is from a 2500 and on the 3500HD chassis. Yes running the speedo with a DIP equipped DRAC. Have extra DIP...
Took care of that mod years ago..Thanks
Thanks Dave
I have been using one of those bins for several years now without a problem...not sure which one one..but the truck has been great. Just replaced the injectors and installed an AFPR. ...
Have a 94 3500HD 2WD (15000 GVW) truck that I installed TPI in years ago. (350 TPI with NV4500 manual trans) Want to flash another prom...what changes should I make to a stock 350 TPI manual BIN to...
Is there a source that can disable the VATS in a 2007 Mitsubishi Eclipse PCM?.
Not sure where to post this...but a buddy came in with a 2000 Monte Carlo SS 3.8 that is lacking power. The check engine light was on so I hooked up my OTC scanner, no codes and none pending? ...
Thanks...only asked because I swear I had one years ago...old age setting in! Did convert an extra MEMCAL last week with a ZIP socket...it's in a car right now.
Do any of the GM OEM OBD1 MEMCALs have removable proms or are they all permanently attached?
THANKS for the detailed response...really appreciate it!
Have a feeling my 27SF512 chips are the problem (had them for many years) and ordered a new batch today. While I wait for the proms to arrive seeking help with RT Bin Stacker...I opened their help...
No EGR FLAG listed....
In the parameter list the enable EGR feature is not labeled as "enable temp" but does have "enable EGR if % of TPS is met"...going to just change it to max TPS position.
...
Thanks all...you guys are great.....finally making sense.
Thanks Dave...an original AUJM is 16.0 KB, the attached bin is 64.0 KB (labeled wrong?) Not sure which mask to use with that attached bin, $6E, 32 or $32B in the 1227165.
Not identified....anyone else have an idea which mask to use?
A stock AUJM is 16.0 KB this one is 64.0 KB
Thanks Dave
My fault for being away from this forum for a long time. A couple years back in order to flash for example a 2002 411 pcm you either had to buy expensive hardware and software or send your pcm off...
Thanks guys..sorry for the slow response...have company. WASyl..bin enroute
Thanks trlrider...as mentioned earlier...it was a case of bad chips.
Thanks...don't have TunerCats
The ecm is a 1227165 with aftermarket burned chip.....how do you determine which mask to use to read and write the 27SF512 (32B.xdf or 6E.xdf)
Thanks
Thanks both TunerPro and TunerPro Rt are Ver 5.0
When I try to load it in TunerPro RT I get this message.....if I burn the chip in plain TunerPro...do I even need the ads?
FYI I also have a MiniPro TL866CS programmer (which I like & comes with many adapters)...upgraded the drivers for Windows 10. Same result - indicates chip is erased...but then shows that it's not...
Thanks again!
Burning a chip for an 88 TPI MAF engine with EGR delete plate. After selecting EGR Disable ..would it be advisable to also set the EGR On at 100% TPS position and EGR Off at 0% TPS position (or...