it os compatible PCM, it is all about flash whether it will use some signals or not.
best regards
Type: Posts; User: WASyL
it os compatible PCM, it is all about flash whether it will use some signals or not.
best regards
If You won't hit stall wall then nothing to be changed with torque converter swap.
I have swapped 8HP70 Jaguar transmission to 2011 Yukon RWD truck. PCM was reprogrammed to manual transmission so that BCM and PCM would control starter relay properly. Now my issue is that cruise...
Innovate is most problematic one, I prefer AEM (but it is with gauge or 14point7.
i'm looking for drivers/installer file for Moates Extreme ALDL cable, their website is down and can't find them on internet, can someone sher version that works on Windows 10 ?
best regards
Send me an email to cwbiuro@gmail.com asking for tune and I'll send You my one, it is '95 SD Tune using WBo2 for lean cruise and 13.1:1 WOT, auto trans with 3200 stall converter.
thanks
no stretched timing chain, just installed new one, opti is new too, just these chinesse opti's that customer bought come so inaccurate, 96-97 PCM treats -10 to +7 as not to request MIL but i dont...
I just swapped PCM from 96-97 to 94-95. Thru 96-97 PCM i have checked that CKP: Lo Res Angle is -9 deg (new timing chain set and distributor), so now on 94-95 should i advance or retard whole...
as MAF tuning is new to me (im SD guy) i have question how to use log.
Lets say AFGS 46-50 and 51-55 log shows +7%, does that mean i need to multiply theres g/s valuses in tune file by 1.07 ? and...
Try Open Loop and see if this behavior continous
Thank you for the explanation :-)
Best regards
I wonder why does MAF cars need to be tuned? Is there something I don't know or understand? As example let's take GM TPI MAF car.
MAF (mass airflow sensor) reads current airflow very very accurately...
That means - if every other stuff is ok - that there was issue with flashing.
still working on that nitrous thru EGR control. I don't know how gm/sec value is calculated so is it possible to do patch that does this:
table "26c2 MIN EGR DC% vs airflow" change load value...
Does any of GM ecm/pcm has resistance or voltage table for fuel/oil pressure? I want to make pressure safety switch and need calibration for known (and cheap) sensor.
awsome tool, comes handy when doing lots of tuning with different ECM/PCM but similar engine setups.
nice work, but if you know how to weld why not open up that intake manifold to breath more air ?
Test that is the one. The other one is just for reading codes thru some basic applications not for flashing pcm
VXdiag Nano is J2534 cable that should work.
Any news on nitrous patch ?
Ok thanks
Best regards
Is there any chance by far to add slider for speedometer scalar so that it is easier to calibrate speedo. I do know there is a spreadsheet but I must be to dumb to use it cause every time I try it...
WB should be around 6-10" from collector and before cats.
I have never played with Baro correction so can't help You here. But i have been at 100 feet and at around 2900 feet too and never needed to adjust anything in SD mode.