4l60E perameters

**lionelhutz** · 08-10-2021

Well, I took a quick look and he set the maximum line pressure scalar to 125psi and he also went over 96psi in the main pressure table. Both of these strongly point to him being clueless about how the auto data works together.

The psi tables and scalars aren't really in psi. They are just a number that points to the column in the force motor tables (columns 0 to 96). Since the force motor tables only go up to 96, the "psi" numbers should also be limited to 96.

I never looked any deeper.

**JD1964** · 08-10-2021

Originally Posted by lionelhutz

Well, I took a quick look and he set the maximum line pressure scalar to 125psi and he also went over 96psi in the main pressure table. Both of these strongly point to him being clueless about how the auto data works together.

The psi tables and scalars aren't really in psi. They are just a number that points to the column in the force motor tables (columns 0 to 96). Since the force motor tables only go up to 96, the "psi" numbers should also be limited to 96.

I never looked any deeper.

Thanks for the reply! I had my reasons for suspecting these settings were not right

Do you have a recommendation on what items I should change and what to change them to in order to give me a good starting point?

**lionelhutz** · 08-10-2021

Originally Posted by JD1964

Thanks for the reply! I had my reasons for suspecting these settings were not right

Do you have a recommendation on what items I should change and what to change them to in order to give me a good starting point?

The V4P bin from here is a good starting point.

http://gearhead-efi.com/Fuel-Injecti...ull=1#post2437