I have successfully created a good fuel map with my Ostrich 2.0 for my old Saab 900 that has Bosch LH2.2 EFI. Now, my next step is to program this data to an eeprom.
This is my first ever attempt to try and program an eprom. The original eprom is an Intel 2732, however I have a blank NSC27C32Q-45 eprom that I would like to program instead.
I have a TL866II+ programmer with it’s original software. My NSC27C32Q-45 eprom can be found in the lists of different ICs and I picked it and did a blank check and pin check, all good! However, When I try to program, it just says ”programming failed”.
Found some threads here mentioning something about offsets etc, yet none of the tricks mentioned seemed to work for me. Is there someone here who could help me? Given that you have read this far, it has probably dawned on you that I am not yet so familiar with programming, but you have to start somewhere I guess
Reply With Quote
Bookmarks