Need some chip advice for new cam install.

[trlrider]

you know it sounds like you're talking about two similar cams, why don't you just fire it up, give it a bit of gas, let it get into closed loop, and see how it does?
it probably wont be so bad. i can almost promise it'll run well enough to break in the cam.

Ditto! Your new cam will not be far enough off from the old worn one to worry about for start up. Run it, get some data logs, tune from there.

[joegreen]

Ok thats what i will do. Thanks i just wasnt sure if i might run into issues but it sounds like all will be good. Then i can tune.