orginal tune last.bin and DA3 X (1).xdf I tried this one you sent also none will work
orginal tune last.bin and DA3 X (1).xdf I tried this one you sent also none will work
That bin is full of garbage data f3 and 33. I think you should revise the reading method. You can also read via aldl line with flashack program. But writing back is another case.
I used a burn 2 and read memical and chip why is it not reading correctly could it of been tuned with hp tuners or something like that causing the problem Im kind of stuck now I have another stock pcm should I try and make a whole new tune I dont even think Im capable of doing. get it good enough to get it back running and not blow up any advise is appreciated Laney
Maybe using non optimal settings during reading the memcal. Try contact moates for troubleshooting. Or a complete step by step of what you are doing, so we can spot some trouble points. There is read and verify so it is very hard to read garbage bin without knowing it.
i agree something is being done wrong
show us a screenshot of your settings for reading
and a picture of how the chip is inserted into the burn 2 as you are reading it
maybe your chip is inserted into the zif incorrectly, which is really hard to do because moates puts instructions right on the thing and then it comes with a manual with a picture showing how to insert the chip
also give us a picture of the chip itself nice and clear so we can read the numbers
Ok I will try and record the whole process as I do it and post for you guys to help me figure out what I’m doing wrong
I hope that I am doing something wrong and you can set me straight I’ve never really posted or anything like this before I am so appreciative that you guys are willing to take the time to try and help My daughters 16 mazda 6 is acting up so soon as I get it scanned and get it diagnosed I will get the video posted on my download thanks again
awesome. good luck with the mazda, i've done that dance.
like kur4o mentioned you could try reading the bin with my flashhack tool if you wanted, over the ALDL port (see tool in my signature), it's free.
it has a tool called 'aldl universal read'
since it's a 32kb bin and the device is f4 you have to go into the parameters tab and set:
device id to F4
memory size to 8000
read start to 0
read end to 7FFF
it's basically using your ECM as the prom reader
but it should read with your programmer too... so lets solve that problem or it might have trouble writing as well.. flashhack wont help you there.
Posting Permissions
Reply With Quote
Bookmarks