That is the issue, understanding his literature...

So, if i leave closed loop on as normal, set MIN/MAX BLM & INT TO 128 and turn P.E to 100% only, then that should be a correct V.E learn, right??

Then i save it, upload it into a new bank, and do it over and over.. Target P.E AFR is 12.8:1


I plan to log it also while i am doing this.......


Question however.. What if "14.7:1" isn't "128" on mine?!?


What i mean is where i run a LT4 HOT CAM, i have overlap etc, so what if 128BLM is actually 13.8:a AFR according to the wideband?!? I also have a wideband 02, does good, 13's-15's going down the road, i just still have that slight rich smell on gas, i figure changing the injector size from 30 even to 31.5 or 32 should do the trick...

This way i can leave the fuel pressure up at 43psi with vacuum as it was soft top end when set correctly to 43 without vacuum. Runs like a raped ape at the slightly higher pressure setting. ZZ430 Clone.


I just didn't wanna mess with that open loop stuff due to the tables being so far off of stioch with my plan of closed loop operation being the end goal and all.