Hi Dave, I'll send you a message shortly.

I'm going to confirm continuity in the appropriate places tonight after work, but the ZIF installation didn't exactly go smoothly. I have some soldering and circuit board experience, but hardly an expert. One of the circuit board traces came partially off with the original socket so I had to repair it by running a little wire to the appropriate ribbon cable pin at the end of the daughter board. I triple checked continuity everywhere and ensured every place had continuity where it should and none where it shouldn't but still something must've gone wrong. In hindsight, I shoud've just stuck the modified ZIF into the original socket, but I liked the cleanliness of Dave's design with the ZIF being attached directly to the board. I used a Burn 2 & TurnerPro and believe that I set the offsets correctly. It ran correctly at first, no SES light. I have tuned OBD II stuff before, but this is my first with OBD I.