repin from 8062 to 7730

[dave w]

Also make sure you un hook and remove the knock sensor ESC module!! This is built into the memcal in the 7427. The knock sensor hooks directly to the pcm on pin B15. Attach your old wire B7 to that pin, then cut off the old plug from the esc module and attach the knock sensor wire (usally blue) to the signal wire (usally yellow with a stripe, I think red) This will connect the knock sensor to the pcm. You will also need to get the correct knock sensor. Get one for a 95 1500 with a 350 for a auto trans. The connector on it should be black, not white.

Are the pictures below accurate?

B7 KNK.jpg

ESC.png

[TriumphR3]

Are the pictures below accurate?

B7 KNK.jpg

ESC.png

Yes sir they are. No disrespect intended. I just wanted him to understand to be sure and sever the wires from the ESC module before connecting them together. The picture might lead someone to believe you just jumper the wires together while still attached to the module.

[dave w]

Yes sir they are. No disrespect intended. I just wanted him to understand to be sure and sever the wires from the ESC module before connecting them together. The picture might lead someone to believe you just jumper the wires together while still attached to the module.

Good point, I will update the note in the .pdf.

1228062 to 1227730 Pinout (gearhead-efi.com)

[dave w]

Good point, I will update the note in the .pdf.

Updated:

Modified ESC.JPG

[TriumphR3]

Updated:

Modified ESC.JPG

�� spot on mate.

[TCoupe]

I Thank you! I will do that. I was thinking, that I was to jump it. I have the harness a done (I hope) other then to do that. I have it waiting to do it. It's cold out, and I have it inside, to work on it as I get time to. Thanks again guy's, I really appreciate it! I started this to long ago, I need to get it back on the road again.