'411 Transients

[kur4o]

Which obdx device do you have.

You can try to get latest drivers from their website, and upgrade firmware if there is any.

ANother test will be to get it working with universal patcher logger.
utiliies->logger->settings tab->select device->connect

[Jim Blackwood]

The OBDXPro GT.
About the battery charger, I have a 12v battery in the simulator. I switch on the battery charger to charge it up. I can switch on either or both so it's easy to run on just the battery and charge it afterwards. I expected the battery to be a reasonably effective filter but apparently not.

I just downloaded and installed the software from the OBDXProGT page, seemed odd that there were about 4 or so install cycles but I went through the complete process. Tried to connect with both PCH and Universal Patcher, on com3 with a usb cable and then on com4 and com5 with bluetooth. No joy. PCH did say it found ATZ then failed to switch to DVI. UP just gave me a connection failed.

Jim

[kur4o]

Can you test with j2534 device selection, in patcher and hammer.

[Jim Blackwood]

In logger it says "32534 client: Device initialization fail.
IN PCH if I say OK without running test it tells me an update for the OBDX Pro scantool is required so I went to the update download site and downloaded and installed every update that looked like it could be related to the GT then went back to PCH and got the exact same result. Trying Test brings up the same dialog which happens right after it loaded DLL. On com3 (usb) it fails to switch DVI, on com4 (BT) access to com4 is denied, on com5 it times out.

Incidentally, the laptop does not beep when the GT is plugged in, if that means anything. My desktop PC does though. Guess I could try the install there but it won't help me much on tuning the car. Though I suppose I could always bring in the ECM and put it on the simulator. Do my logging with HPT.

Jim

[kur4o]

The update might not have completed successfully.

Here is some other user with similar issue fix.

Well finally got it sorted. Firmware wasn't loading by clicking on the download even though it was telling me it was ready. Went into my computer/ program files and found it there so tried from there and it's working finally. Thanks everyone for your help and Tazzie you're a genius

[Jim Blackwood]

OK, did that. Found the updater and it did a firmware update and then confirmed that it was up to date.
Logger now appears to connect on J2534 (Device initiation complete) but not on com3 or BT. No improvement from PCH.

Jim

[kur4o]

Can you try pcm hammer with j-device selected, and post debug log.

You can test logger if it have actual communication in dtc tab when connected, test some random buttons.