AEM 03-4110 logging problem

[Sledhead2]

Ok the quick recap.

95 Truck, 16197427, updated the bin file to read wideband, I am using Advanced $0D TP5 v251.xdf, and A217_0D_v250.adx.

So tonight I had laptop, with TunerPro RT V5 connected to the truck and running.

Cold start: the tunerpro dash was reading 12 and AEM gauge was reading 11 and 10.

Hot: Tuner Pro Dash was reading 10 and AEM was reading 14.

Here is a snap shot of of the gauge when it was running it showed a min/max of 10 and 12.

Ok so does anyone know why I am not matching?

Does this tread address my problem? http://www.gearhead-efi.com/Fuel-Inj...light=wideband

Capture.PNG

[dave w]

I wonder if the attached .xdl will show the same?

Capture.jpg

[Sledhead2]

I will down load and try tonight

Thanks

[dave w]

Does this tread address my problem? http://www.gearhead-efi.com/Fuel-Inj...light=wideband

No, that thread is for AEM part number 03-0300

[Sledhead2]

Dave the file you up loaded appears to be a data log??? what am I looking for in it?

how do I know if the tuner pro is seeing and displaying 0-5 volts correctly?

[dave w]

Dave the file you up loaded appears to be a data log??? what am I looking for in it?

how do I know if the tuner pro is seeing and displaying 0-5 volts correctly?

Load the data log file into TunerPro RT and playback the data log from post 2.

[Sledhead2]

so I played it back and the wide band did not move or show any data.

I played back using my bin file, advance 0, and 217 files.

[dave w]

Try using the attached .adx file to playback the data log I posted. The attached is the .adx file I'm using, so I know it's good.

The exported .csv data log shows WBO2 data.


Closed Loop.jpg

Open Loop.jpg