New and im lost

[stport68]

Hi everyone i just bought my moates cable for my 94 LT1 my computer is running windows 7 and that is as far as i have gotten i have been messing with this stuff for a few days now and i can not figure out what im doing wrong i can not connect to my car and i dont even know if i can connect to my cable. this tuning stuff is all new to me. im more the old school turn a screw and change the idle. but i do know how to operate a computer. i just need help getting off the ground and started. i feel stupid because i work on cars for a living. but i just can not figure this stuff out or how to work with it with my car. im afraid i wasted my money. HELP!!!!

[EagleMark]

You need TunerPro, then the ADX and XDF file from this thread:
http://www.gearhead-efi.com/Fuel-Inj...rmation-EE-EEB

TunerPro Tutorial:
http://www.gearhead-efi.com/Fuel-Inj...is-a-must-read!-)

And installing the cable:
http://www.gearhead-efi.com/Fuel-Inj...to-TunerPro-RT

[stport68]

im sorry i do not mean to sound ingnorant or something but on the one page that pertaines to my car there are alot of files do i need to load them all or what. also i do not see any that are for the 94 camaro LT1 so im still a little lost im starting out my day today to try and read my car and see what it is doing and maybe beable to see on my laptop my cars data. so i have about 12 hours to figure the out or im going to have to wait another week to try again when i have more time. i read all the links you sent me and i still do not under stand how to , or what to look for to start. sorry

[EagleMark]

1994 Camaro LT1 engine is $EE.

[stport68]

do i need to get a ASDU .bin file or chip or what

[EagleMark]

No, that was just the bin file used in Tutorial. Your bin file is what you read from your PCM. Neither XDF or bin is needed to connect to data. Just ADX.