16196395 and High Impedance Injectors

[corvairnut]

Latest thing Im doing is getting away from 2 wet TBI and to a single dry TBI with Injectors at the base where the carbs used to be. Got everything fab'ed up and didnt even have a fuel leak, but it wont run.... and appears to be a fuel problem. It will run it by spraying fuel into the throttle body, but stops after I quit "being the injector"

Im using a 16196395 ECM and high impedance injectors (Ford 27 lbs x 2). Have taken the injector out to observe the injector and it has a weird spay rythym, but spraying. I thought I read somewhere, I think on the forum where the 16196395 can handle up to 4 injectors without modification. Bill at binder posted about putting a wire on a resistor to use many injectors, but dont know if this is the same thing.

Now my Question: Can I run high-Z injectors (Ford EV6) on a low-z (16196395) ECM?

Ohms of the injectors I was testing:
GM TBI - 1.8 ohms (Low-Z) - FACTORY
Ford EV1 Injector - 2.8 ohms (Low-Z)
Ford EV6 Injector - 12.0 ohms (High-Z) (the one I was testing)

[corvairnut]

I think I have the answer. Bill from BinderPlanet has a writeup on how to splice two resistors to make the 16196395 and its cousins for multiport injectors. I asked for clarification and said doing this mod would make the ECM a high-z controllable ECM.

http://www.binderplanet.com/forums/s...d.php?t=101802

I will give it a try tomorrow and report back.

[EagleMark]

All that was developed long ago on Thirdgen.org. We have all the writups guys have done on other sites and info on the MPFI conversion here:
http://www.gearhead-efi.com/Fuel-Inj...Information-OD

What Bill is telling you is WRONG!!! There is no need to jump resistors unless you have 8 saturated injectors.

[corvairnut]

Well... you may be right. The injector done the same thing with the jumpers on and off... which is not enough fuel per pulse (45 lbs of line pressure). I'm driving 2 EV6 (high-z) injectors (#30 lbs) instead of 2 TBI injectors (#27 lbs) with the about the same FPH rate and not doing a MPFI conversion. Common throttle body with tubing to each intake (Corvair). Injector is at base of tube at the entrance of the intake log on each side. I thought this would be simple as all I'm changing is the location of the injector. I have ordered low-z injectors to see if that makes a difference as the TBI injector puts out a lof of fuel and currenty the high-z injectors are not.
Since Bill is Wrong... your saying the 16196395 style ECM will fire the high-z injector normally?

[EagleMark]

Since your not in MPFI I'm not sure what the injectors would do? Did you install the Injector Offset vs Batterey Voltage? Injector Flow Rate?

[corvairnut]

Removed the jumper on the resistor as it DIDNT make any difference. Offset vs battery voltage was already set in my bin. The flow rate was right for TBI, but changes when you go to CPI mode and done that on the fly back and forth.

Solution: Went back to a low impedance injectors and started right up using my exisiting bin with only 1 mod. It seems to run much better and easier at idle in CPI mode. You have to reset the lbs per hours when changed from TBI mode. Starting getting dark and I have this engine sitting on the movers cart...so its back into the shop and awaiting some new Low-z injectors that are the right size.