My Dual TBI Camaro Project

[gregs78cam]

I am up in Spirit Lake, you are in CDA right? I am pretty sure we conversed a bit on TGO.

I did not know the BBC IAC had two wires swapped. But yes first thing is to get it to idle at a decent rpm, and not pig-rich. It idled at about 700rpm with a carb, so that is my target with efi. As of Friday, my problem was more with getting a solid data link between the PCM and laptop.

Cam is 224/230 @.050, 0.525/0.524 lift. Not real big for two reasons. I knew I wanted to go EFI eventually, and the engine was built for lots of torque down low, not HP @6500rpm.

I do have an LM-1 and it is running through the PCM in the datastream.

I am at work so i don't have any more pics but here is one from 2003 when I built the engine and another from my post on TGO.