TCII not changing VIN

[Playtoy_18]

Yes,I have key-on and 12v on my bench harness,though they run to a common feed.I used Winflash to change the VIN as well as attempting to change VIN manually (in tuner,HxD,TP) and nothing has worked. Everything was done using full flash as well.
I read it out using Efi to confirm and still not changed.
Not sure what's up,doublechecked and i'm updated on winflash and TCII.
I'm using an optima to power the bench harness,plenty of voltage and fully charged.


I'm going to try just programming a completely different .cal and see what happens.

[EagleMark]

But does your bench harness have a Key On switch as well as power? After programming the Key On switch needs to be turned off, while power is still on! Then the VIN change will be kept. If both powers are off after program? Then no go!

Then VIN has to have same amount of digits, can't be one short...

EDIT: I think there's something wrong with your .cal file as I flashed it in a PCM and tried to change VIN and it will not change, even one digit at end?

[Playtoy_18]

Look at the pcm serial via hex,is there amything there?

[Playtoy_18]

Okay,I just switched pcm's and am using another.But I wanted to try it in the vehicle since it has the proper ign/batt power.
And sure enough mark it finally worked.
What gets me is I tried to change it on the vehicle last night pretty sure and got nada,must be remembering incorrectly.
I will rewire my bench harness,it has an off/on switch and that is it. I will just swap the switch to the ign circuits and wire the 12v direct.
Never had this issue,but I also generally only do VATS stuff on the bench usually and like mentioned before don't mess with ViN much. (I stay away from mailorder work,if I possibly screw something up I like to put hands on tools to verify/diag in person).


Thanks for the tip.

[scuzz]

I had same problem just last week. It had been about a year since I had used my bench top cable, and I had forgotten that I had to use switch on cable instead of switch on power supply.
I thought something was wrong with TCII, but after a couple messages back and forth from TC, I realized that I needed to shut cable switch, cause he said that part of flash was after switch was off.
I tried it and worked.
I had just forgotten procedure.
Maybe that might help.

[Playtoy_18]

Sorry,thought I had updated this.
I rewired my bench harness as well and mark was right on.
Bypassed the battery constant around switch and everything was gravy.