Has anyone out there found an easy way to remove the clear(ish) coating on the in memcal knock board?
Thanks
Has anyone out there found an easy way to remove the clear(ish) coating on the in memcal knock board?
Thanks
Not any easy why.
Why would you want to?
The man who says something is impossible, is usually interrupted by the man doing it.
To examine the on board traces to try get an understanding of how this board is working.
Perhaps also to run some benchtests with a scope and signal generator.
Acetone works on other clear coating on boards?
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
Just to complete the loop. Acetone did not work. It looks like it is silicone based as
Silicone-B-Gone did soften the coating and then it washed off with soap and water.
Bob
ooops....
Bookmarks