Hello everyone. I have been fighting for over two weeks to make my truck run and I am failing. I originally read the bin the truck last ran good with into tunerpro. Well, stupid me read the eprom wrong the first time, then read it properly but erased the chip in the eprom. I didn't think there would be an issue since I had the bin saved on my computer. So I tried to run the bin from the APU1, and the truck barely ran. So I checked everything and burned the bin onto a chip. Same thing, the truck barely runs. It sounds like the timing is way retarded and it pumps out black smoke like a diesel truck. I am using the correct xdf (Advanced $0D TP5 v251) and adx (A218 trans1 $0D tp5) files for my particular truck, which is a 1994 K1500 with a 16196395 ecu and BJLH original bin. I tried to go through and compare the two bins and see where I might be going wrong but am not seeing anything obvious, and I am so confused with all of this. I have no idea which way to turn. If anyone could please help me and point me in the right direction of what I am doing wrong it would be greatly appreciated. I will attempt to attach the current bin I am trying to use to make this thing run. Thank you all so much. Eric
Bookmarks