0D 7247 in 94 k1500.
Just rebuilt the tranny and it showed thee was a poblem as i was getting clutch material in the pan. A lot of it. So did a pressure gauge test before tear int down. I determined it was low line pressure. Now in limp mode it makes 240psi. Assuming it was rebuilt right, i notice with a gauge on it again the pressure is higher but not rising past 130psi at aggressive throttle. Data logging show the torque signal pressure never goes above 127 which seems to correlate to the pressure gauge. In tprt I tried to change the PE line pressure vs input speed. It will not go over 127. I put 200 and save it. It comes back as 127. What gives? Any other tuning suggestions to change line pressure as load inceases?

TIA
Pima.1971