Speedo Calculator for TunerPro

[X-cabsquarebody]

I was hired to wire in an 95 LT1 that was swapped into a 95 GMC truck. Its all together and on the road. I have a few bugs in the swap that I'm trying to help owner stamp out. I'm new to tuning, and I'm using TunerPro. The ECU isn't commanding the fans to turn on. I found out the values were set at 160* on fan1 and 180* for fan 2. BUT,,,, its suppose to be in Celsius. That was easy. I would like to correct the speedo. I found a link to a spread sheet to calculate it, and tell me what to change in TunerPro. BUT I cant open the spread sheet. I cant get either program to down load the be able to use it. Any other options? Can someone take my info and put it in the calculator and possible post it here?
Thanks

[1project2many]

Sure. Upload the spreadsheet or post a link.

[X-cabsquarebody]

http://www.gearhead-efi.com/Fuel-Inj...7&d=1324172648

Here is it is. I cant open it so don't know what info needs to be put in it.

[1project2many]

Capture_06252014_072124.jpg

This is for Tunercat. I can't tell you if the data has the same name in TP but I'm sure someone here can help with that part.

There are a few questions... does the speedo still go through the DRAC (white box under dash)?
Can you get final drive ratio and rolling circumference of tire?
What trans is in truck?
Is cruise control and ABS still installed and expected to work?

[X-cabsquarebody]

Trans 4l60e. 95 model
Gear 3.73
16188051 LT1 ecu
265-75-16 tire, 30" tall , 94.25 circumference
Speedo, cruse, abs all are hooked up to the LT ecu and work. The speedo reads 5mph fast at 55mph. That is what I'm trying to change.

Also the link is under TunerPro bins in this forum. I have no way to know it was Cats cause I can't get it open. Sorry.

[1project2many]

No problems, it's all good.

Can you see the numbers in thisCapture_06252014_094621.jpg?