sorry to necro this thread but it's the only info i can find about segment swapping outside a commercial utility. I'm attempting to swap the code for a manual transmission to an auto calibration on an 0411, OS 12212156 . above notes that Trans section starts at 0x16a00, and including Trans Diag, ends at 0x1c2ff. in the calibration i have, i've got 00016a05 through 0001c2fd, is this the same code block, or do i not have something displaying correctly in Hex Workshop
i may be an idiot there, think i figured out what i was doing wrong, in any case, if i copy from 00016a00 through 0001c2ff, and load the binary in EFI live to verify the checksum, engine and trans diagnostics no longer match. is this normal? afraid to flash the binary like this and brick the pcm
Bookmarks