Good evening everybody. I don't know exactly where to go, or where to start. as far as asking questions. I love this whole new tuning, tweaking stuff to ECM eprom chips. I know i have a lot of research to do ahead of me.
But for the question i Have for right now.. wait, back-up..... truck specs first
chevy 350 TBI
New cam. (no idea what it is) as far as tuning, should i take the intake off, see if i can see the number and look it up to get the specs?
or through tuning i can figure it out?
straight exhaust - Xpipe - dual glasspacks, no cats
so, since I'm trying to figure out the Tunerpro, chip burning road, instead of carb'ing it out. obviously i want to keep the ECM.
I guess my main question is are their definition/XDS/TDX/ADX files in this site where i can find other guys tuned chips other guys have changed/tweaked that might be similar to my setup that i can load/compare. burn to chip and see if the truck runs better?
Where would i start in tuning to compensate of a mild cam? <-- my apologies for this question if its too broad, or if i could find the answers somewhere in the forums, theirs just so much information to decipher, read, understand. its hard to know where to go.
Like i said, I'm still very new to programming, and i know i have lots To read up on. So any and all advice, tips pointers is greatly appreciated :)
Bookmarks