Well today was a good day. Last night I went out at around 10PM, and leveled the lathe, took off the back gear cover and made a few adjustments to the geartrain, tweaked the gibs and ways, and got the thing running sweet. Today, I went out to replace the wheel bearings on our '98 Grand Am, and found I need to do the brakes as well. It just so happens that the rotors just barely fit on the lathe. I got one mounted up, the tooling set up and put a nice finish on it. I had to make a trip to Pull and save to get a ABS plug bracket, and pads from Napa on the way, then I came home and turned the other rotor, replaced the tie rod ends, and took it for a drive. Not bad for half a day's work (12 hours).
Bottom line.......I am very happy with this lathe so far.
Bookmarks