new $EE tuning thing!

[RobertISaar]

Steve, you use IDA? I can upload both halves of my disassembly, be easier to explain things that way. my P66 V6 ADX has some mode4 stuff in it already but I have more defined in the disassemblies than what I have in the ADX.

stuff I can answer off-hand: the T-side does primary communications, mode4 stuff is passed to E-side over SPI. E-side mode4 bytes are 360-366, T-side mode4 bytes are 34A-355. I've got a decent amount of both decoded.

BLM cells are located from 100-142 on E-side(an odd byte exists between the cell groupings, it might be an idle only cell?). 100-10F are Right/Rear O2 sensor with CCP active BLM cells(1-16), 111-120 is " .... " with no CCP, 122-131 is Left/Front O2 sensor with CCP active, 133-142 is " ...... " with no CCP.

[steveo]

i do have ida and would be awesome if i could have a look

[RobertISaar]

this should do it. default views should open up to the areas I was just playing with.

[steveo]

awesome thanks man! that's next on my list after i meet my current goal of a successful flash!

[steveo]

i've run into this before but i have IDA v6.5 and when i try to load your disassemblies, it tries to upgrade the version of the database, then says 'database corrupt' and bails. never could figure out why

[RobertISaar]

I'm running 6.1 now but those were originally started with 5.5 IIRC. I upgraded them from 5.5 to 6.1 without issue?

[steveo]

weird. i'll see if i can figure it out, otherwise i might just see if ya can get me an ascii dump of hex n comments (i think ida does that?)