WBO2-Tuning Spreadsheet

[TNoutdoorsman]

Please update me with your thoughts / results after using the spreadsheet.

dave w

I obviously have a lot of learning to do. I guess I need a chips for dummies course first.

[CDeeZ]

Dave, a few questions.

What is the password to unprotect the spreadsheet. I can't edit or enter any data into it.

And, I'm using Gregs Advanced $0E TP5 v252.xdf. It has only one WB02 table. It appears to resemble something close to Open Throttle in the 7427 with $0E. I can extrapolate data to come up with values to tune the idle table, I'd likely just copy what I have from the main Open Throttle VE table. This particular XDF also goes up in MAP in increments of 5 KPA... Which both tables in the 7427 start going up in increments of 10 KPA after what, 40 KPA?

[CDeeZ]

Nevermind I got past the password protect I had to enable editing, oops.


I have tried pasting in the entire CSV file generated by TPRT into the spreadsheet, as well as pasting just the AFR data into it. Also pasted in the existing VE tables of course and the spreadsheet keeps spitting out the exact same values of the existing VE tables? What am I missing here?

[dave w]

Please post the TPRT .ADX file and .XDL file you are working with.

Gregs Advanced $OE TP5 v252.xdf definition file is for editing the .bin file, not data logging.

dave w

[CDeeZ]

[dave w]

The spreadsheet "Filters" out open loop data (Column AJ). Only "Closed Loop" is used by the averageif formulas. All the data in the 1234test.csv IS "Open Loop", so the spreadsheet will "Filter" out all the data from the 1234test.csv.

dave w

[CDeeZ]

So is there any way to make it work for something that is running open loop? I was considering running this thing in open loop full time and adjusting if/when necessary.

I think it must not be going into closed loop because there is no NB02 in there currently. Was hoping I could just stay
Open loop and rely on the wideband exclusively.

[dave w]

Yes, the spreadsheet will work if you change the data in Column AJ from "open" to "closed". See post #31 thru #33 in this thread.

dave w