Ill Read more of it later but I did look at the diagrams, I havent tried to find a 708 but the diagram looks the same as the 88 quad 4 diagram im comparing to my 90. My 1990 has a Crank sensor input wire from ignition module to ECM where the older ones do not have the crank sensor input to ECM. Im thinking just remove that wire and put other wires in the right place and try it... I have another ig module from different year with less pins than the one Im using, I just though of, so Ill go dig it out and see which wires are not there. Not sure what would happen, if anything, if that wire isn't hooked up, incase module wants that wire.

When you say "1X wire" what does that mean? 1x a signal or is that the name of wire....I have learned more than anything that i know very little about this stuff!!
By the way my spark ref angle is 74, not sure if that matters...

Thanks again!!! I really appreciate your time and help!!!