FITech systems

[lionelhutz]

I've run a TBI and home made adapter plate on a 2101 Performer intake and it worked quite well without any fuel distribution problems. I pretty much just used a 1/4" plate of aluminum and hole sawed 2 holes for the TBI bores by centering the TBI over the plenum.

[Loyd]

the first adapter plate was for 2" bore and would not work with the 1 7/8 bore. vacuum leak due to tbi too close to the opening. got the smaller which locates the tbi in the center of the intake. no more leaks. think I will get a 2" tbi with larger injectors. would be a lot cheaper than an after market FI unit and no worried about ecu stuff

[1BadAction]

the first adapter plate was for 2" bore and would not work with the 1 7/8 bore. vacuum leak due to tbi too close to the opening. got the smaller which locates the tbi in the center of the intake. no more leaks. think I will get a 2" tbi with larger injectors. would be a lot cheaper than an after market FI unit and no worried about ecu stuff

I actually have a bone stock factory bbc throttle body fresh off my truck if you're interested.

[Loyd]

I actually have a bone stock factory bbc throttle body fresh off my truck if you're interested.

how much? answer PM

[Tom B.]

Does anyone have a copy of the FI-tech pro cal software? I am tuning a car w/o power adder TB. Fi-tech is no help. I would rather pay some one for a copy of the software than give Fi Tech another dime.

[Tom B.]

I have the files now if anyone needs them. I should have the drivers for the handheld asap.

[Tom B.]

Found the drivers.

[Nasty-Z]

I believe I have all of the Pro Cal files , but still lack the handheld files .

If you are in the sharing mood I would take a copy of what you have and I will return what I have just to be sure the files are the same .

tomsnastyz@yahoo.com is my email address

Thanks

TOM