Probably not, but paying $55-80 for something you can make for $30 is against my "religion". Also, I had all the parts I needed to make a cable in my parts drawer, which was a factor. So if you're intimidated by soldering buy a ready-made cable. Or, learn a new skill - it's easier than tying your shoes.
Trimalyzer does work for MAF tuning. I haven't messed with it since last fall so all the details are a little fuzzy, but unless you've changed sensors or modified any intake plumbing you shouldn't need to make very drastic changes to the MAF calibration.
Last edited by spfautsch; 03-13-2018 at 06:35 PM.
I don’t mind soldering, I build rgb guage clusters and headlights. I just stay so busy at work it’s hard to find extra time. Time is more valuable than money to me. Intake is only slightly modified, cold air intake 52mmtb and air foil so I probably won’t have to worry. I researched and found a/c pressure is the best to tie in wideband
What you need is the adapter from the link.
https://www.ebay.com/itm/FT232RL-3-3...8AAOSwrklVMjIp
You can buy several and have spares. It is the best design from all usb to ttl and proved the most durable.
Tie rx and tx lines and connect ground.
It all started in this thread. After testing different layouts and chip configuration, this one proved best.
http://www.gearhead-efi.com/Fuel-Inj...ight=converter
Actually this board is intended for arduino applications. The price went down slowly over the years and the design improved.
The JY-MCU module with the resistor and diode that I mentioned was found inside a Red Devil River cable.
But yes, you can find the module and a 10' USB extension cable for $5 and wire the module under the dash running the cable out for your PC.
The red devil river cable was the one I had planned on using prior to this thread. They seemed to have good reviews
Well I downloaded tunerpro and eehack. Ordered the parts to build a cable, and found some bin files stock and otherwise to check out. Engines not back in my car yet so not much I can do until go time. On badz28 I found a tune for a setup like mine but it was an autocar, figured I could look through and check out what was done vs stock
Yes, if you buy a complete cable it will work without modifications. If it doesn't, you'd return it for a different one.
I'm not sure where you're looking but http://www.reddevilriver.com has a cable for a decent price.
Bookmarks