Quote Originally Posted by Tom H View Post
I still hope to support the DX cable. I hope someone can run a quick test for me.

Test is just this... Set up your cable talking to a terminal, plugged in with ignition on.
Send the following lines

AT SP2
AT H1
AT S1
DX PT1
DX SD 4C 10 F0 28 00
DX SD 4C 10 F0 27 01
DX SD 4C 10 F0 27 02 91 94

Select the transcript, copy it to a post here. This will let me know just how much effort is needed to bend the software to match the cable.

If the results look bad to you, please re-test but omit the DX PT1 line. In this case please un-plug and re-plug the cable, re-test and send both transcripts.

Thanks,
-Tom

I will try to give these tests a go this evening or tomorrow.
And thanks for sharing your hard work on the physically addressed mode commands!

Jim