Hey Dave
I got home back early and copied the original chip as a 64k file as per your settings, the truck would not run.
I opened the chip in the hex editor and all lines of code were 00 80 00 80 00 80....
so I tried it a second time, read, verify and write verified then repeated read to verify the chip I burned and it all looked good, spark table matched, so I put it back in the truck... still no run.
So, I took the memcal back to the truck to put on the g2 and realized the handle faced the wrong way on the g2 flip (to fit in the computer) as compared to the memcal position so I put the chip in backwards to the flip and it fired no prob.
Now I got a good burn and a good chip, thanks so much.
next, to start playing with it... (the settings)
This chip is a BMHM I could not find it in any of the .bin files here, so should I post it in the bin files? I'll just post it here for now if you want to put it some where.
Bookmarks