LS1 Swap into 1992 Chevy Pickup

**brian617** · 05-06-2019

What pump are you going to use Dave?

**dave w** · 05-06-2019

Originally Posted by brian617

What pump are you going to use Dave?

Basically, using a TPI pump to replace the TBI pump. The TPI pump is nearly identical, size wise, to the TBI pump.

dave w

**brian617** · 05-07-2019

I was thinking that or the 96 5.7 Vortec pump. Both fit the hanger with minimal effort.

**dave w** · 05-07-2019

Originally Posted by brian617

I was thinking that or the 96 5.7 Vortec pump. Both fit the hanger with minimal effort.

See pic below for the pump we ordered. It hasn't been installed. About $120, with shipping fees.

dave w

**PlayingWithTBI** · 05-07-2019

Originally Posted by dave w

See pic below for the pump we ordered. It hasn't been installed. About $120, with shipping fees.

dave w

Here's what I used

https://www.summitracing.com/parts/ado-ep381

**dfarr67** · 05-07-2019

I used the Walbro 255- pleased its quieter than the Carter. Curious where you taking air from, I used a 6.5 diesel filter assembly which takes air from the original location pass fender.

**dfarr67** · 05-07-2019

Last week I grabbed a 98 vortec truck's ecu mount, washer res, battery tray to fit on the drivers fender area.

**PlayingWithTBI** · 05-07-2019

Originally Posted by dfarr67

I used the Walbro 255- pleased its quieter than the Carter. Curious where you taking air from, I used a 6.5 diesel filter assembly which takes air from the original location pass fender.

Right now I'm just using the full flow filter - I was thinking about cowl induction but I don't know if I want to spend that much$$$