Check your base gasket on the throttle body. If no vacuum leaks, Adjust the minimum air screw to close the throttle blades for approximately 10 IAC counts at hot idle. Clear PCM codes. You have constant knock retard. You could possibly have a bad knock sensor or bad filter board on the memcal. Do you hear any spark knock/ping? You can simulate a knock sensor on this pcm with a 3.9k resistor. It thinks a knock sensor is there but gets no knock feedback. You have extremely low timing everywhere in the datalog and that is why it is lacking in power. I also see the timing all over the place with a constant throttle/load. Something is making the PCM pull timing. As always, make sure all of the engine and PCM grounds are in good shape. Make sure plug wires aren't inducing noise back into the PCM through the engine harness. Get your fault codes cleared up and not returning then datalog again posting results here.