RamJet PCM options?

[Kitch]

It looks like it's a mefi4a based on the 88962717 part number and the 88961967 part number for the harness.

I was wondering if that sensor was the IAT but though that it wasn't a very useful place for it if it was.

I read somewhere that there may have been one or two IAT's.
One IAT in the manifold or one for the intake duct but I'm not sure, I would have though you just needed one.

[In-Tech]

You can verify if it is a mefi4a, the last three digits of the delphi part number underneath the ac-delco sticker will end in 479. The mefi4,a,b only uses one IAT. I couldn't find any copyright infringements in this document but if found, the attachment needs to be deleted. Hopefully this information will help you with your project. :)

[Kitch]

Hi Carl,

Thanks for the pdf, it's got a lot of good info.

I'm still considering my options but Holley's Terminator X Max setup is looking like a good way to run the EFI and control the trans.

About the only integration I think I'd need from the Holley setup is a signal to run my speedo and for the ABS in my van.

Has anyone run this setup?