Good evening all,
I hope this is in the right forum,
What I would like to know is, is there a way to know what calibration segment is on your pcm?
In other words, lets say your original programming was for a 4L60E and you swap a segment from a
vehicle that's supposed to have a 4L80E, but the bin file ( from this forum) doesn't specify that information.
How can you be sure you have the segment for a 4L80e. If I might also ask, within TunerPro, how can you
know if the pcm is set up for DBW? I swapped my OS for one that has more support and now I can't seem
to get the electronic throttle to work. When I test ran the motor on my engine stand, it worked. I am considering
swapping the old OS back and see if it works again. Now the motor is in the car with the new OS and it does not work.
I have not completed the install, and I have not started engine yet, I have only powered the circuit with a battery and cables.
I used LS Droid to swap but all you get is cal. numbers.
I Didn't intend to make such a long post. I hope someone can help.

Thanks so much.