My PCM is already set up for 4L80E and the shift pattern switch type has been set to manual mode via pin 31. From my understanding, pin 71 only loads a different shift table, while pin 31 allows full manual shifting. The shifter I purchased (Lokar INS0169) has the normal P-R-N-D positions. The shifter also has a sport shift mode where you move the stick over to the right and you can bump shift up and down. There are 3 switches built into the shifter, all SPDT. One is used as a latching switch and the other 2 for upshifting and downshifting. I may be misunderstanding the wiring instructions but it seems it won't work the way i need it too. I will have to check tomorrow with an ohmmeter to see if they will. I attached the switch wiring instructions, that should make clearer what I am trying to achieve. Again I appreciate all your help.
Wiring the Manual Mode and Bump-Shift Switches
The Lokar Electronic Sport Mode Shifter can function just like a traditional automatic transmission shifter if you wish. It is not necessary to even connect the wiring for the Manual mode switches if you do not want the "bump-shift" functionality.
There are three identical switches on the Sport Mode Shifter, Fig. 14 and Fig. 15 The switches are single pole double throw (SPDT) momentary switches. However, the Manual mode on-off switch is being used as a "latching" (instead of momentary) switch in this application.
Each switch has black, blue, and red wires. The red wire is connected to the normally closed (NC) terminal. The blue wire is connected to the normally open (NO) terminal. The black wire is connected to the common (COM) terminal.
The Manual mode on-off switch is top-center on the left side of the Shifter base. The Manual mode on-off switch has continuity between the black and the blue wires when the Shifter is in the Drive (or Overdrive) position (EXCEPT Ford 6R80, when the lever is in the rearmost Sport position).
Manual mode is activated by pushing the shifter lever to the right when the Shifter is in the Drive (or Overdrive) position (EXCEPT Ford 6R80, when the lever is in the rearmost Sport position). The Manual mode switch will then provide continuity between the black wire and the red wire. Pushing the lever back to the left turns Manual mode off.
The downshift switch is at the front of the Shifter, and it is activated by pulling the shift lever rearward and releasing it when in Manual mode. At rest, the switch provides continuity between the black wire and the red wire. Activating the downshift switch provides momentary continuity between the black wire and the blue wire, signaling the transmission controller to command a downshift.
The upshift switch is at the rear of the Shifter, and it is activated by pushing the shift lever forward and releasing it when in Manual mode. At rest, the switch provides continuity between the black wire and the red wire. Activating the upshift switch provides momentary continuity between the black wire and the blue wire, signaling the transmission controller to command an upshift.
Please note that with a fully electronic transmission, the shifter only sends a request to the transmission controller to perform a specific task. The response to a shift request may not be immediate, or in some situations may not happen at all, depending on the vehicle speed, engine load or RPM, and how the controller is programmed.
Bookmarks