I thought I had all this done correctly, but apparently not. I have an LM2 hooked up through my A/C port but I am having an issue with the conversion in EEhack. I have both the wideband and EE hack set at 0 Volts = 7.350 and 5 Volts = 22.390. The conversion factor must be automatic in EEhack and it comes up as 3.008N+7.35
When I try to run analysis however it gives me trims that are off by 50-75%, which is not right, as it runs perfect and my narrowband trims are right on the money. Also when I view the innovate while driving it is within a % or two, and it appears accurate in the EEhack display before I run analysis. Where have I gone wrong oh great gurus?
Thanks,
Roy
Bookmarks