I am running a 16197427 PCM on an AMC 360 V8 engine. This is my 3rd TBI conversion, second '7427 conversion but it's been several years. I am running a modified $0D code. All the other sensors read correctly, so I feel that I have the correct XDF and acquisition files in TunerPro.

I am running a Bosch 4 wire O2 sensor. I have double checked the heater wiring as well as the sensor wiring. They appear correct. The heater circuit on the sensor measures about 5 ohms and when I probe the O2 sensor with the engine running, I get aprox 0.100 volts, I think the sensor is good. It better be. I purchased a new one.

But when everything is hooked up, wit the engine running, TunerPro shows aprox 0.440 volts. and it NEVER moves.

That tells me it is not reading the sensor. The other thing that tells me the sensor is not being read is that ALL my BLM #s are 128. And I KNOW that is wrong.

Any idea on where to start?? I swapped PCMs and there was no change. The swapped PCM read a constant 0.453 volts.

TIA!