7730 using $88 mask.
I've installed new injectors (Ford 302), changed bpw vs volts table and zeroed out bpw vs bpw table. I've also set the Multec fixing factor scaler to 0.
Starts fine, runs fine until shut off, then won't restart until cooled off, like 30 minute.
During no-start condition, has spark, has fuel pressure, doesn't have injector signal.
I tested injectors both for ohm and amperage and are normal. The old injectors went back in, thinking I'll start over, but didn't revert back to old tune and same no start when hot condition, so now I'm thinking it's the tune.
Is it possible to overheat the injector drivers with a tune?