It had a stock LT1 module in it (with the code still there) So I put an LT4 module in. I have new sensors and the connectors that run from the KS to the PCM (port 22 blue i think if i remember right off hand) are new as is the wires so that i can rule out any burnt or corroded wires and i have fresh one running to the blue wire (prong) on the PCM where the original wire was, i connected the new ones there. After all that it seemed better but as you can tell i am not where it should be. But iv been driving it like this since January, is it really bad for me to drive it? I know its certainly not good but HOW bad is really the question i guess
Bookmarks