Look at wiring to your fuse panel, the ECM needs Batt power all the time and it also needs Ignition on power. This power has to be steady from key on, to crank and back to key on. Un-interrupted!
B1 and C16 need 12 volt all the time.
A6 needs power when key on.
Use this sheet to check voltages with key on:
http://www.gearhead-efi.com/Fuel-Inj...0&d=1331599730
Now lets start with ALDL wiring.
ALDL port pin A to Ground
ALDL port pin B to ECM A8
ALDL port pin E to ECM A9
That's it, nothing else, like this diagram.
http://www.gearhead-efi.com/Fuel-Inj...5&d=1331599707
AutoProm move both switches in.
TunerPro load your XDF, ADX and bin file like you have in those pictures.
TunerPro hoover over the Up Arrow and it should say "Upload Current Bin to Emulator" and click it.
Then over three Icons is Verify Emulator Ram against Current bin" If it Verifies OK?
Then over to next Icon and Emulate, click.
Now you are emulating the bin loaded in TunerPRo from the AutoProm.
Turn key on and watch for it to come on, blink and stay on?
I know everyone wants to use the dashboards but I'm not sure how each one is set. You need to right click on everything and choose what you want there. So let's leave that alone for now.
Open Item lists to Sensor Data to see what is happening.
Now go over to Double arrows and Acquire Data (Connect/Disconnect). What's happening?
Bookmarks