does anyone happed to have the dissasembly tool and a pair of calipers handy to measure the diameter of the hole in the end?
i'm going to turn one on my lathe and couldn't find the diameter of the hole anywhere on line.
does anyone happed to have the dissasembly tool and a pair of calipers handy to measure the diameter of the hole in the end?
i'm going to turn one on my lathe and couldn't find the diameter of the hole anywhere on line.
The one I have measures .120 ID, and .130 OD.
79 Jeep Cherokee, AMC 401, T-18 manual trans, hydroboost, 16197427 MPFI system---the toy
93 Jeep YJ Wrangler, 4.0L, 5 speed, 8.8 rear, homebrew hub conversion and big brakes, hydroboost, 2.5in OME lift, 31x10.50's---the daily driver
99 Jeep WJ Grand Cherokee limited, 4.0L, auto, 2wd, leather and power everything, 99% stock---the long distance highway ride.
WHen you get it dialed in, make a bunch to sell some in For Sale forum?
1990 Chevy Suburban 5.7L Auto ECM 1227747 $42!
1998 Chevy Silverado 5.7L Vortec 0411 Swap to RoadRunner!
-= =-
This is the one I have, works fine. Might be hard to beat the price.
http://www.amazon.com/Delphi-Packard...atherpack+tool
79 Jeep Cherokee, AMC 401, T-18 manual trans, hydroboost, 16197427 MPFI system---the toy
93 Jeep YJ Wrangler, 4.0L, 5 speed, 8.8 rear, homebrew hub conversion and big brakes, hydroboost, 2.5in OME lift, 31x10.50's---the daily driver
99 Jeep WJ Grand Cherokee limited, 4.0L, auto, 2wd, leather and power everything, 99% stock---the long distance highway ride.
thanks, thats what i was looking for.
i'll just have to make sure my land rover doesnt find out i got these measurments from a jeep.
its cheaper to buy but making my own gives me an excuse to use my lathe.
i'll use 1018 for the shaft and aluminum for the handle, i ussually make a few extra when i make parts.
Made one from some brass last night. Now that I know it works I'll make a few more out of steel
Steel or better yet, stainless. The more resistance to bending, the better. Sometimes the tab gets stuck and you'll apply quite a bit of force without realizing it.
i have plenty of 1/4" 1018 and a few feet of 1/4" 4140, i considered stainless but i don't have any on hand that would be suitable
Bookmarks